DTH Hammer Breakout Bench Tools for Dismantling 3-24 DTH Hammers
aluminium pressure die casting,aluminium die casting manufacturers,Security die casting Parts Shenzhen Kangneng Fusheng Die Casting Products Co., Ltd. , https://www.knfsdiecasting.com
Specifications
1. For disassembling the dth hammer
2. Easy operation
3. Low cost
4. For 3.5" to 10" hammers
5. Semi-automatic
It's a kind of bench to disassemble the dth hammers. The hammers range can be 3" to 10" .
The operation method as below:
1). Put hammer on the bench.
2). Adjust the position of the hammer and wrench; Use wrench to block the top sub side of hammer; Let wrench and jack in the same face.
3). Fix K-shaped base with nut.
4). Fix wrench with nuts.
5). Shake handle of jack slowly till top sub away from hammer.
6). After top sub dismantled, grease the jack, release nuts, discharge the K-shaped base and turn around the hammer.
7). Adjust the position of hammer and wrench; Use wrench to block the drive chuck of hammer; Let wrench and jack in the same face.
8). Fix hammer
9). Fix K-shaped base and the wrench with nut.
10). Shake handle of jack slowly till drive chuck away from hammer.
Technical data:
Model
CX-5(manual)
CX-8(manual)
ECX3-8A(electric)
ECX3-8B(electric)
ECX3.5-10(electric)
Operate hammers
3-5"
6-8"
3"-8"
3"-8" (Atlas copco)
3.5-10" (Sandvik)
Length
920mm
1100mm
1900mm
1060
1060
Width
510mm
620mm
900mm
930
1050
Height
875mm
875mm
850mm
1050
930
Weight
200kg
230kg
450kg
800
800
Â
We have aluminium pressure die casting Security die casting Parts components including: camera bracket, camera casing, camera base, spherical camera casing, camera base, motor end cover, bus camera casing, car camera casing, security radiator and other security accessories-aluminium die casting manufacturers.