Truck driving skills, you know?
Everyone knows that trucks are relatively large, so it is much more difficult to control them than the car. Therefore, not everyone can control a truck. Only those who pass a strict examination can qualify for a truck. Although the difficulty of driving a truck is relatively great, it is not surprising that it is just as easy to master it. If you have mastered some tricks, it is not so difficult to drive it. Let's introduce Xiao Bian to the driving skills of the truck. When starting the truck, the operation must be precise, especially the timing of releasing the handbrake. When starting uphill, the stability of the clutch node is guaranteed and the throttle is slightly increased. And when shifting, it is necessary to timely, especially on the uphill, we must advance the file to ensure reserve power, and we must pay attention to the point when shifting, that is, use the two feet to step on the clutch, then reduce the file and add the air throttle. When you go downhill, you must hang the low gear and avoid the neutral gear. Because the mass of the truck is large, the inertia is relatively large. If you hang the neutral gear, it will lead to untimely braking and cause a traffic accident. After starting the truck upshift, when entering the normal driving route, the accelerator pedal should be stepped on immediately, and then the speed should be increased to a higher gear than this gear. Then observe whether the engine and the vehicle will shake when the clutch is lifted. If not, it means that the vehicle speed is just right; if there is a phenomenon of shaking, it means that the vehicle speed is low, and the speed should be increased. If the vehicle is slipping backwards, it means that the speed increase is high. At this time, only need to quickly shift the gear lever to the first gear, and then speed up, and repeatedly use this method until the gear lever is gradually replaced The most upscale. In addition, when the vehicle is approaching a downshift, if the vehicle is approaching a bump, but the vehicle speed is still relatively fast, the brake can be used to further reduce the speed of the vehicle over bumps until the vehicle does not experience large bumps. Due to the high center of gravity of the truck, if the bumps are too severe, the truck will easily roll over. In addition, in the process of further deceleration using the brake, if the vehicle is about to shake, the clutch pedal can be stepped on. After deceleration, the speed is reduced to a few gears, and the shift lever is switched to several gears. The above is about the tips of truck driving. I hope that I can help the owners. Car Interior Accessory,Car Decor Accessories,Car Dashboard Accessories,Best Car Interior Accessories Ningbo Yonghai Auto Products Co., Ltd. , https://www.nbyonghai-manufacturer.com
