Gear pump fault diagnosis and troubleshooting

1, gear pump produces severe vibration and noise

1) caused by tight sealing. The solution: repair pump body and pump cover plane (0.005).

2) The shaft seal on the shaft seal aging. The solution: replacement.

3) less fuel tank, pump empty. Solution: Come on.

4) back to the oil pipe exposed liquid, instantaneous negative pressure to make the air back irrigation system. Solution: should be inserted into the liquid.

5) The pump is too high, the low speed is the pump oil chamber can not be vacuum and inhale the air. The solution: try to shorten the relative distance.

6) into the oil inlet resistance or large into the air into the oil pipe. The solution: cleaning filter or increase the amount of filtration or reduce the diameter.

2, due to mechanical vibration and noise

1) Pump and coupling coaxiality.

2) due to oil pump gear wear and tear caused by noise, replace the oil, and strengthen the filter. Solution: clean the pump or replace the pump.

3) poor pump needle roller bearings. Solution: replace the bearing.

3, other causes of vibration and noise

1) into the oil filter is blocked caused. Solution: wash the filter.

2) Large oil viscosity produces noise. Solution: Choose a reasonable solution.

3) oil into the oil aperture is too large to produce noise. Solution: appropriate to reduce the diameter.

4, gear pump output flow is not enough, the pressure does not go up

1) Suction into the oil blockage and lack of flow. Solution: wash the filter.

2) The pump discharge large and the flow is small. The solution: repair cover and gear face or change the pump.

3) The oil temperature is too high, the internal discharge pressure is low. Solution: refuel cooler.

4) The oil viscosity is too high, oil absorption resistance or viscosity is too low, large internal leakage. Solution: Choose the right hydraulic oil. General 32 (40 degrees)

EVA Traction Deck Pad

EVA Traction Deck Pad is a kind of for water sport like surfboard, kite board or SUP, it can provide a strong traction for people enjoying the water sport.

EVA Traction Pad, also knows as tail pad, is to be applied on the tail of surfboard. With arch and kick tail, the surfer can control the direction and stability when surfing.

EVA Traction Deck Pad
EVA Deck Pad is normally applied on kite board and SUP. The whole thing is about traction, non-skid, and strong grip to control.
EVA Traction Deck Pad
We are proud to offer 24 different textures for customers. There are different degree of traction among them, which meets the different traction requirements from different customers. Some will be more grip, some will be more smooth and comfortable. And we are always in process to develop new textures, to provide more and more options to customers.



Eva Traction Deck Pad,Coaming Pads,Eva Deck Grip,Eva Traction Pads,Eva Grip Pad,Sup Deck Pad

Huizhou City Melors Plastic Products Co., Limited , https://www.melorsfloor.com